Max 49001 Gebrauchsanweisung Seite 35

Hammer safety warnings
• Wear ear protectors. Exposure to noise
can cause hearing loss.
• Use auxiliary handle(s), if supplied
with the tool. Loss of control can cause
personal injury.
• Hold the tool by the insulated gripping
surfaces when performing operations
where the application tool or the screw
could contact hidden wiring or its own
power cord. Contact with a "live" wire will
also make exposed metal parts of the
power tool "live" and shock the operator.
• Use suitable detectors to determine
if utility lines are hidden in the work
area or call the local utility company for
assistance. Contact with electric lines can
lead to � re and electric shock. Damaging
a gas line can lead to explosion.
Penetrating a water line causes property
damage or may cause an electric shock.
• When working with the machine, always
hold it � rmly with both hands and
provide for a secure stance. The power
tool is guided more secure with both
hands.
• Secure the workpiece. A workpiece
clamped with clamping devices or in a
vice is held more secure than by hand.
• Always wait until the machine has come
to a complete stop before placing it
down. The tool insert can jam and lead to
loss of control over the power tool.
• Your product is � tted with a BS 1363/A
approved electric plug with internal fuse
(ASTA approved to BS 1362). If the plug
is not suitable for your socket outlets,
it should be cut off and an appropriate
plug � tted in its place by an authorized
customer service agent. The replacement
plug should have the same fuse rating as
the original plug. The severed plug must
be disposed of to avoid a possible shock
hazard and should never be inserted
into a mains socket elsewhere. Products
sold in AUS and NZ only: Use a residual
current device (RCD) with a rated residual
current of 30 mA or less.
Preparation and adjustment
Turning the support handle
The support handle (7) can be rotated
around the drill chuck to a position to suit
- e.g. vertically under the machine, horizontal
out to either side.
Changing bits
Insert the chuck key in one of the three holes
on the side of the chuck (8), turn to open.
Insert the desired bit in the chuck and turn
the chuck key the opposite way until the
chuck has a � rm grip on the bit.
Check that the bit is in the centre of the
chuck and is secure.
GB
35