Magene S314 Bedienungsanleitung Seite 4

English
Cadence Mode
1. Reinstall the battery. The red indicator blinking indicates
that the sensor is in cadence mode.
2. Install the silicone pad at the bottom of the sensor and use
the silicone ring to install the sensor on the internal side of the
left crank.
3. Rotate the crank and search the sensor using a device
supporting the Bluetooth or ANT+ protocol.
Pairing and Settings
Indicator
Green indicator blinks
Red indicator blinks
Red and green
indicators blink
alternately
1. The sensor only broadcasts via Bluetooth or ANT+ when
properly installed and being used. At this time, you can search
and connect to the sensor using the corresponding device or
app.
2. If using the Bluetooth protocol, the sensor can only be
connected to a single device or app. To use another device or
app, disconnect the sensor first.
3. To connect the sensor to an app, search and connect the
sensor using the app. This cannot be done via the system
Bluetooth of the phone.
Device Status
Speed Mode
Cadence Mode
Low battery
4
Red light flashes