Magene S314 Bedienungsanleitung Seite 22

FAQs
1. Why cannot I search and find my new sensor?
Answer: Check whether a battery has been installed on the
device.
Check whether the app used is compatible.
Reinstall the battery to see if the indicators blink..
If these steps do not work, contact our after-sales technical
support.
2. Why cannot I search and find the sensor after having
used it for a time?
Answer: To reduce power consumption and extend its
service time, the sensor enters sleep mode after not
detecting any cadence or speed data for 60 seconds. It will
be automatically woken up and transmit data when you start
cycling again.
3. Why does the indicator not go on after I reinstall the
battery?
Answer: This is because of the energy storage effect of the
capacitor. Reinstall the battery 10 seconds later.
The electrode clip in the battery holder is pressed down
when the battery is being installed. The electrode clip does
not spring back, resulting in poor contact. Address the issue
simply by lifting the electrode clip.
The battery is dead. Replace it with a new battery (model:
CR2032-3V).
If these steps do not work, contact our after-sales technical
support.
4. Does the sensor have the data calculation latency
issue?
Answer: The sensor measures data with a geomagnetic
sensor, instead of the traditional solution combining a reed
switch and a magnet. This simplifies sensor installation but
causes a certain degree of latency in data calculation.
5. Why does the sensor run out of battery in a short
time?
Answer: The sensor can normally operate for 500 hours.
(Depending on the temperature and environment of use, the
actual operating hours may vary.) Do not install the sensor if
it is not in use. Otherwise, the sensor will be woken up
frequently, which will accelerate power consumption.
If these steps do not work, contact our after-sales technical
support.
22