Operating The Hand Brake; How To Accelerate : Multi-Control System - Micro COLIBRI Bedienungsanleitung

Operating the hand brake

To activate the hand brake (drum brake on the front wheel), pull the left hand lever.
Operating the hand brake activates the motor brake automatically.

How to accelerate : Multi-control system

This electric scooter is operated by either thumb throttle or motion control.
The default setting uses the thumb throttle to start when the rider is kicking from
approx. 5km/h. The alternative is to use the kick control function. In order to change
the riding modes or select other features, please see the Micro App instruction manual.
It is also possible to switch to motion control without the App, as follows: Press the
thumb throttle, release it and wait two seconds. Do it for three times and at the end
step one time on the rear fender.
In motion control mode, the sensors detect the kicking movement (= push-off from the
ground) the rider makes, and the scooter subsequently provides support with energy
similar to that of an electric bicycle with a support motor.
Important information:
● Motion control only becomes active from approx. 5 km/h. This means the rider
must use body power alone to accelerate to 5 km/h (1-2 kicks) before the initial support
is noticeable.
● The scooter keeps the speed which the rider accelerates to by kicking off the
ground.
● Pressing the brake triggers a sensor which stops the motor.
EN
22
Book.indb 22
WARNING
Please note that riding with electrical support
takes getting used to.
The acceleration is much greater than with
a normal kicking movement. This type of
acceleration is initially unusual and can be
abrupt. When riding for the first time, please
be extremely cautious.
26.08.19 11:10