Safety; Instructions And Safety Notes; Directives And Ce Marking Used; General Safety Instructions - Kessel Minilift F Anleitung Für Einbau, Bedienung Und Wartung

2.

Safety

This chapter lists all generally valid safety notes and technical instructions. All the notes and instructions must be heeded
and complied with during transport, set-up, operation, maintenance etc. The operator is responsible for all members of
staff keeping to the following notes and instructions.
2.1.

Instructions and safety notes

These operating instructions uses instructions and safety notes for property damage and personal injury. To mark these
clearly for operating staff, these instructions and safety notes are printed in bold type and marked by hazard symbols. The
symbols used comply with the generally valid directives and regulations (DIN, ANSI etc.).
Safety notes always start with the following signal words:
Danger: Serious or fatal injuries can occur!
Warning: Serious injuries can occur!
Caution: Injuries can occur!
Caution (note without symbol): Significant property damage can occur, total loss is not excluded!
The signal word is followed by the naming of the danger, the source of the danger and possible consequences. The safety
note ends with a note on avoiding the danger.
2.2.

Directives and CE marking used

Our systems are subject to
- various EC directives
- various harmonised standards
- and various national standards.
Precise information about the directives and standards used can be found in the EC Declaration of Conformity at the be-
ginning of these operating instructions.
In addition, various national regulations are assumed as the basis for the use, assembly/installation and dismantling of the
product. These include, for example, accident prevention regulations, VDE regulations, equipment safety law, etc. The CE
marking is attached to the type plate, which is located on the motor housing.
2.3.

General safety instructions

• The system may not be installed and/or dismantled by one person alone.
• All work (assembly, removal, maintenance, installation) may only be carried out with the system switched off. The
product must be disconnected from the mains power supply and secured against being switched on again. All rotat-
ing parts must have come to a standstill.
• The operator has to report any faults or irregularities to his superior immediately.
• The system must be brought to a standstill immediately if defects occur which endanger safety. These include:
• Failure of the safety and/or monitoring devices
• Damage to important parts
• Damage to electrical devices, cables and isolation.
• Tools and other objects may only be stored in the designated places in order to guarantee safe operation.
• When work is carried out in closed rooms, care must be taken that there is sufficient ventilation.
• During welding work and/or work with electrical equipment, care must be taken that there is no explosion hazard.
• To exclude suffocating and poisoning, it must be guaranteed that there is sufficient oxygen available at the workplace
and that no toxic gases occur in the working area.
• Directly following completion of the work, all safety and protective devices must be attached again or made function-
al again.
• The accident prevention regulations and generally recognised rules of good engineering practice must be complied
with. We point out that according to the (German) Product Liability Act we are not liable for damage caused by our
equipment if the instructions and regulations in these operating instructions are not complied with. The same provi-
02/2022
SAFETY
29/128