Lotus SMARTIME 50035/1 Bedienungsanleitung Seite 9

This product should not be worn when show-
ering or used in a sauna/steam room as it is
not possible to prevent steam entering the
watch. Any water damage to the product due
to non-compliance to this instruction will not
be covered by the warranty.
1. Functions
introduction
1.1 Buttons
Press the button to enter Menu from Dial.
When in a function, press the button again
to go back to Dial. Long press the button to
power on or off the smart watch.
1.2 Charging Guide
Magnetic charging is as shown below. This
watch supports a PC USB or 5V charger. It takes
about 2 hours to fully charge the battery.
Be aware that the two pins of the USB
cable are not allowed to contact the conduc-
tor at the same time, or it will cause short cir-
cuit and burn.
1.3 Shortcut functions:
1) From Dial, swipe from right to left to enter
Data. Swipe to left again to enter Heart rate
measuring and again to see Sleep monitoring.
2) Swipe down to for shortcut settings.
3) Swipe right for notification history.
4) Swipe up for Menu and when in Menu,
swipe again to see whole Menu
5) Press on the Dial to enter change Dial
mode. Swipe to select and click to confirm.
1.4 Shortcut Setting menu
From Dial, swipe down to see Date, Bluetooth
connection status, Power and Time.
1) Power on and off.
2) About; FW version and MAC.
4) Stopwatch
5) Brightness
6) Settings.
1.5 Notification
Connect to the Lotus SmarTime application.
You need to give the app the permissions to
obtain the SMS or other notification of the mo-
bile phone first. Then the device can display
the notifications on mobile phone.
1.5.1 Incoming call notification
Enable Incoming call in the app. The screen of
watch lights up and vibrate when there are in-
coming calls.
1.5.2. Messages notification
Enable SMS in the app. The watch pops up
message notification and vibrate when there is
incoming message.
1.6 Data
Health Data is activated by default. Swipe to
left on the Dial interface to enter the Data in-
terface. Data interface shows steps, distance
and calories. The data will be cleared after 12
pm every day. You save the data by being con-
nected to the app every day.
1.7 Sports mode
1.7.1 Select sport (Walking, Running, Cycling,
Rope skipping, Badminton, Basketball, Foot-
ball) and start by tapping that sport. Pause by
swiping right and continue by swiping back or
tap √. Stop the session by tapping X.
1.7.2 The work out can only be saved if it lasts
for more than 1 min. Or you will see "too lit-
tle data to save" when stopping. You save the
data by being connected to the app every day.
1.8 Blood pressure
Wear the watch tight on your wrist. Select
Blood pressure and it starts to measure. The
measurement will be completed in 10-20
seconds.
1.9 Heart rate
Wear the watch tight on your wrist, select Heart
rate and it starts to measure. The measurement
will be completed in 10-20 seconds.
9 9