neotone NTK-180Z GEN-2 Bedienungsanleitung Seite 15

After mounting, you can adjust the angle of the camera.
■
The thin two-core cable is used for the power supply. Connect the two wires
to the two contacts of your reversing light. To do this, you need to know their
polarity (measure or check the circuit diagram): The red cable must be
mounted on the positive pole of the reversing light and the black cable on a
ground contact.
■
If your vehicle has a tailgate with the license plate, you may have to extend
the supply cable. At the top of the tailgate there is a cable duct with
additional cables through which you can then route the cable to the rear
light carrier. Make sure that the cables are routed cleanly so that the cables
cannot be broken by opening and closing.
■
Safely lay the cable up to the monitor / radio in your vehicle.
Release the radio from its mounting slot and pull it out to the front. There is a
cinch socket for camera-in in the cable harness of the ISO cable connector
(on the back of the radio). Put the yellow cinch plug on it.
■
Connect the red reverse cable to the reverse connector on the radio
Your reversing camera is now fully connected. Your switched on radio should
now switch to the image of the camera when reverse gear is engaged.
9
45
EN