Werbung
Using the T20P
Preparing the Intelligent Flight Battery
Only use official DJI flight batteries (
flying and charge according to the corresponding manual document.
Preparing the Aircraft
Unfold the M3 and M4 arms, and fasten the two arm locks. Avoid pinching fingers.
Unfold the M1 and M2 arms, and fasten the two arm locks. Avoid pinching fingers.
Unfold the propeller blades.
●Make sure that the battery is firmly inserted into the aircraft. Only insert or remove the battery when the aircraft is powered off.
●To remove the battery, press and hold the clamp and lift the battery up.
●Fold the M1 and M2 arms followed by the M3 and M4 arms and make sure that the arms are inserted into the storage clamps on both sides
of the aircraft. Otherwise, the arms may be damaged.
Getting Ready for Takeoff
A. Place the aircraft on open, flat ground with the rear of the aircraft facing toward you.
B. Make sure that the propellers are securely mounted, there are no foreign objects in or on the motors and propellers, the propeller blades
and arms are unfolded, and the arm locks are firmly fastened.
C. Make sure that the spray tank and flight battery are firmly in place.
D. Pour liquid into the spray tank, and tighten the cover.
E. Power on the remote controller, make sure that the DJI Agras app is open, and power on the aircraft.
● When using for the first time, activate the aircraft using the DJI Agras app. A DJI account and internet connection are required.
Calibrating the Flow Meter
Make sure to calibrate the flow meter before using for the first time. Otherwise, the spraying performance may be adversely
affected.
① Fill the spray tank with approximately 10 L of water.
model: BAX601-13000mAh-52.22V
Insert the Intelligent Flight Battery into the aircraft until you hear a click.
). Check the battery level before
Werbung
