Mounting Spindle Support 232630 And 233449 - haacon 2931 Betriebsanleitung

9. MoUnting spinDle sUpports 232630 anD 233449
These special designed spindel
supports are for placing and
levelling ISO Containers close to
close across the long and small
sides by the multi usable foot and
connecting plates.
Mounting at one container
If the spindle supports are mounted as shown at the figure, the
ground plates will not overlap the container at any side.
spindle support
Placing two containers side by side at the short side
The figure shows how to mount two spindle supports to place
two containers side by side at the short side of the container.
The cross connector implements the ideal distance between
the lower adaption of the ISO-corner.
spindle support
094017_f_gb_spiheb_v
view A
A
fig. 9-1
cross connector
fig. 9-2
haacon hebetechnik gmbh – Phone +49 (0)9375 - 84-0 – Fax +49 (0)9375 - 8466
Placing two containers side by side at the long side
The figure shows how to mount two spindle supports to place
two containers side by side at the long side of the container.
The cross connector implements the ideal distance between
the lower adaption of the ISO-corner.
cross connector
spindle support
Placing four containers directly together
The figure shows how to mount four spindle supports to place
four containers directly together at one corner. The cross con-
nector (2) implements the ideal distance between the lower
adaption of the ISO-corner in both directions.
fig. 9-3
cross connector
fig. 9-4
6