Technical Data; Cleaning And Care - Renkforce RF-CC-800 Bedienungsanleitung

4. Tap the Mode button to change the display mode to suit different presentation scenarios.
1) Panorama Mode – The panoramic view of the room is displayed on the screen.
2) Top and Down – Participants sitting on the left and right sides of the table are displayed separately
at the top and bottom of the screen.
3) Composed mode – Individual frames of tracked participants are displayed at the top and the
panoramic view at the bottom of the screen.
4) Speaker Mode 1 – The presenter is displayed at the top and the panoramic view at the bottom of
the screen.
5) Speaker Mode 2 – Only the presenter is displayed on the screen.
5. To enter Panning Mode, tap and hold the Mode button for 3 seconds.
Under Panning Mode, the AI face tracking will be turned off and the product will automatically rotate
Æ
left to right to capture video and sound.
6. To turn the microphones on or off, tap the Mute button. The microphones are turned on by default.
Blue indicator light on the Mute button = microphones on (unmuted).
Æ
Red indicator light on the Mute button = microphones off (muted).
Æ
7. Once the meeting is over, exit and close the window of the virtual meeting. Close the video conferencing
application.
The indicator lights will turn off.
Æ
8. To turn the product off, unplug the USB cable and power adapter from the computer and mains supply.
Important:
After unplugging the power adapter, the product can still operate if it is connected to the computer
via USB. The cameras will capture video without sounds and AI face detection if used in a video
conferencing application.
CAUTION: To protect your privacy and avoid electrical hazards, always disconnect the
product when it is not in use by removing the USB cable and power adapter from the
computer and mains supply.

10 Cleaning and care

Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage
the housing and can cause the product to malfunction.
– Do not immerse the product in water. Do not rinse the product under the tap or expose to moisture.
1. Disconnect the product from the power supply and connected devices before cleaning.
2. Clean the camera glass lenses with a lens cloth or lens tissue. If necessary, add 1 or 2 drops of lens
cleaning solution to the cloth. Protect the lenses from scratches, impacts or damage.
3. Clean the body of the product with a soft, dry cloth.
4. Store the product upright in a cool and dry place, or in its original packing.
11 Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market.
This symbol indicates that this device should not be disposed of as unsorted municipal waste
at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately
from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by
the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner,
must be removed by end users from the WEEE in a non-destructive manner before it is handed
over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):
in our Conrad offices
at the Conrad collection points
at the collection points of public waste management authorities or the collection points set up by
manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries
outside of Germany.

12 Technical data

12.1 Product
Model No. .............................................. RF-CC-800
Power input jack .................................... 12 V/DC, 2 A
USB-C port ........................................... 5 V/DC, 500 mA
®
12.2 Power adapter
Model No. .............................................. FJ-SW126G1202000E
Input voltage/current .............................. 100–240 V/AC, 50/60 Hz, max. 0.6 A
Output voltage/current ........................... 12 V/DC, 2 A, 24 W
12.3 Camera
Camera array ......................................... Built-in 4 cameras, 5.0 megapixels each
Image sensor ......................................... 1/2.7" CMOS sensor
Supported feature .................................. Adaptive ROI, People tracking
Lens construction .................................. 5 layers of glass + IRCF Elements
Focal lens .............................................. F = 2.49 mm
Resolution .............................................. Input: 4992x928 / 30fps, Output 1920x1080 / 30fps
Frame rate ............................................. Max. 2592H x 1944V @ 30fps 10 bits
Field of view ........................................... Horizontal 360°, Vertical 60°
FOV Top: Vertical +45° up / -15° down
FOV Middle: Vertical ±30°
FOV Down: Vertical +20° up / -40° down
FOV 140° (D), 140° (H), 103° (V)
12.4 Microphone
Microphone array ................................... Built-in 4 digital microphones
Acoustic echo cancelation ..................... Yes
Supported feature .................................. Beamforming tracking
Voice pick-up range ............................... Up to 5 m
12.5 Speaker
Speaker type ......................................... Built-in full-range speaker x 1
Rated output power ............................... 3 W (mono)
Frequency response .............................. 200 Hz to 8 kHz
Sound pressure .................................... 70dB ↑ (@1m at: pink noise 0dB)
Sound playback frequency range .......... 200 Hz to 10 kHz
12.6 Supported
Operating systems ................................. Windows
Video conferencing applications ............ Skype, Zoom, Microsoft Teams, Cisco Webex, Google Meet, and
others
12.7 Environment
Operating conditions .............................. 0 to +40 °C, 10 – 90 % RH (non-condensing)
Storage conditions ................................. -10 to +60 °C, 5 – 90 % RH (non-condensing)
12.8 Other
Product dimensions (W x H x D) ........... 67.5 x 182.3 x 67.5 mm
Weight ................................................... Approx. 447 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represents the technical status at the time of printing.
Copyright 2022 by Conrad Electronic SE.
7/8/8.1/10 or later, macOS X 10.10.5 Yosemite or later
®
*2616565_v1_0922_02_DS_m_4L_(1)