Schritt / Step 2
1. Befestigen Sie die sechs Gewindeplatten (128) am Hauptrahmen.
2. Schieben Sie die untere Abdeckungen (64/65) auf die Stützrohre
(4/5) auf.
3. Anschließend die werden die Hauptrahmenabdeckungen (62/63) auf
die Stützen (4/5) aufgeschoben.
4. Verbinden Sie auf der rechten Seite das untere Computerkabel (50)
mit dem Mittleren (49).
Achten Sie nun beim Einschieben des Stützrohres
(4) auf der rechten Seite darauf, dass die Kabel nicht
eingeklemmt werden!
5. Schieben Sie anschließend das linke Stützrohr (5) ein.
1. Install the two Speed Nut Clips (128) on the Frame Base left and right
side.
2. Slide the lower handlebar covers (64/65) onto the console masts
(notice orientation).
3. Slide the Frame Base Caps (62/63) over the Upright tubes (4 & 5).
4. Connect the Lower Computer Cable (50) to the Middle Computer
Cable (49) on the right side of the unit.
Before attaching the hardware to Step 3, make sure the
cables you just connected don't get pinched in between
the steel tubing. If they do, this may cause issues that
prevent the treadmill from operating properly.
5. Slide thwe right post (5) on the base frame.
05