Schritt 7
1. Befestigen Sie den Verbindungrahmen (26) zwischen den zwei
Stützen (4/5) mit vier Innensechskantschrauben (159).
2. Anschließend platzieren Sie den Getränkehalter (158) auf der
Verbindungsstange (26).
3. Sollte der Not-Aus-Schlüssel (75) noch nicht eingesteckt sein, stecken
Sie diesen nun in die dazugehörige Öffnung am Computer. Ohnen diesen
kann das Laufband nicht betrieben werden.
4. Prüfen Sie nun, dass alle Schrauben fest angezogen sind.
1. Attach the Support tube (26) between the upright tubes (4 & 5)
with four Button Head Socket Bolts (159). Tighten bolts firmly.
2. Place the Beverage Holder (158) on top of the Support tube (26)
as shown in the illustration.
3. Place the magnet of the safety key (75) in between the Start
and Stop buttons (if it isn't already attached). The treadmill will
not function without this in place.
4. Check to make sure all bolts and screws are completely
tightened.
10