Hubix SECRA-1 Gebrauchsanweisung Seite 11

12. LIFE TIME
The lifetime of the helmet with face shield is 60 months from the date of manufacture.
The production date quarter/year (1) and the date of utilization quarter/year (2) are
pressed on the back of the outer shell of the helmet (Fig. 8).
AFTER THE DATE MARKED "UTIL X / XX" ON THE BACK OF THE SHELL [see
Fig.8 (2)] THE HELMET MUST BE WITHDRAWN FROM USE AND DISPOSED
OF.
IN THE EVENT OF AN IMPACT, FALL, APPEARANCE OF CRACKS OR
PERFORATIONS, THE HARD HAT MUST BE DISPOSED OF.
IN THE EVENT OF CRACKS,
DISCOLORATION OR TARNISHING, THE FACE SHIELD MUST BE DISPOSED
OF OR REPLACED.
In normal and standard use conditions, the face shield ensures sufficient protection
for 60 months.
13. WARRANTY
This product is covered with a 24-month warranty, starting from the date of
purchase. The warranty does not cover defects caused by negligence, accidents,
problems resulting from improper use (non-conforming to the manufacturer's
instruction) or physical wear of the product.
SCRATCHES, PERFORATIONS
•
In the event of an impact, fall, appearance of cracks or perforations, the
hard hat must be disposed of.
• Do not modify or remove any of the original helmet components.
• The electrically insulating helmet cannot be used as the only personal
protective equipment during live work.
AND
• Depending on the risk involved in a particular type of work, it is necessary
to use additional protective equipment in addition to the helmet.
• The manufacturer accepts no responsibility in the event of any
modifications of the equipment performed without its permission and in
the event of any additions or replacement of accessories that have not been
approved by the manufacturer or do not constitute a part of the original
hard hat and not adapted to live work.
• Do not apply paint, varnishes, etc. to the hard hat or visor of face shield.
• Do not stick self-adhesive labels on the helmet or face shield without the
consent of the manufacturer.
• Do not use solvents, detergents and abrasives to clean the helmet or face
shield.
• The helmet must not be thrown, dropped or used as a support.
• Before starting work, check that the electrical limits for helmets correspond
to the voltage rating and category or class of hazards that may occur during
use.
• The ARC-W1 face shield can only be used with the SECRA H058S helmet.
• The face shield protects against hazards only when it is completely
lowered.
• Do not use headgear, warmers, etc. under the helmet, which have not been
tested in combination with the helmet. Using the wrong headgear can
significantly reduce the level of protection.
• With the helmet use only balaclavas recommended by the manufacturer.
• Keep the face shield, in particular the transparent visor, clean.
WARNING!