Maintenance - Felisatti T14,4/18L Originalbetriebsanleitung

the cooling, indication changes to red glowing and
charging begins.
3) This charger detects charging status of the
battery and always keeps the battery in full charge
state.
3. Installing and removing battery
Figure 3
1) Installing.
■Set the rotational direction switch at center
position (locked state).
■Insert the charged battery into the slot below
the handle until the battery securely latched
with a click.
2) Removing.
■Push the battery button once and take it out
to remove it.
Always set the rotational direction switch
at center position when inserting the
battery or changing, carrying or storing
4. Power Switch Control
1) Press the power switch once for 3pcs LEDs.
2) Press the power switch a second time for 6pcs
LEDs.
3) Press the power switch a third time for 9pcs
LEDs.
4) Press the power switch a fourth time to turn the
worklight off.
LED Pattern F
Figure 4
Press of power switch
LEDs Light
5. Adjusting LED Head and Handle
Figure 7
The worklight has a LED head and handle that
pivot independently for maximum flexibility.
1) The Handle pivots 130 and three positive stops.
Press the handle release button and move the
handle to any of the three positive stops.
Do not force the handle beyond the 130°
2)The LED head pivots 90 by manually.
Move the LED head by manually rotating it into
any position within the 90 pivot.
Do not force the LED head beyond the
90° range.
the tool.
F F
Figure 5 Figure 6
1 2 3
3 6 9
range.

Maintenance

6
Always keep tool and air ventage clean for
safe work.
1.Environmental Protection
The tool and its accessories contain much raw
materials and plastics that can be recycled after
their life. Therefore, plastic parts are indicated with
their material types so that they can be classified
and recycled for each material type.
Do not dispose of the battery with home
garbage or into the fire or river.
2. What to do when the tool does
not work normally
It is very dangerous for customers to troubleshoot
or repair the tool for themselves, Contact the
nearest A/S center (sales agency) and request for
a service
The repair shall be requested to the
qualified electric speciailst.
3. Y attachment cord
If the replacement of the supply cord is necessary.
This has to be done by the manufacturer or his
agent in order to avoid a safety hazard.
7