Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
Check before Use
1. The power source
■Observe correct main voltage. The voltage
of power source must agree with the voltage
specified in the name plate. (KEYANG LITHIUM-
ION battery both 14,4 and 18V)
■Make sure the rated voltages in the electric drill
and the battery are the same. When the rated
voltage of the battery is higher than that of the
electric drill, the motor can be damaged by fire.
2. Attachment of the battery
Make sure the battery is attached correctly before
you use the electric tool.
Make sure the battery is attached in
the body of the tool tightly before you
start operation. When the battery is not
attached tightly, it may be fallen during
the operation and cause an injury in the
top of your foot.
3. Polarity of the battery
When the polarity of the battery is not
correct, it may cause the trouble of the
switch. Also, the reversal of the rotating
direction
can
4. Trial run
Before starting the work, wear protection (goggles,
safety helmet, ear plugs, protective gloves) and
runthe tool in the direction avoiding other persons
to see if the tool is operated normaly.
4
Specifications
1. Specifications
Model
Rated voltage [V]
Illumination Source
LED Head Pivot [°]
Handle Pivot [°]
Run-time[hr]
(9pcs LED Setting)
Battery Type
Weight[kg] (without battery)
Rated voltage [V]
Battery Model
Capacity [Ah]
Charger Model
Input Voltage [V AC]
6
bring
a
dangerous
situation.
T14,4/18L
14.4
18
9 pcs LED (Light Emitting Diodes)
90
130 (with 3 positive stops)
14.4 V, 1.5 Ah
18 V, 2.6 Ah
10
20
Lithium-Ion
0.35
14.4
18
FL14415
FL18026
1.5
2.6
F144; F180
220 - 240
Input Frequency [Hz]
Output Voltage [V DC]
Charging Current [A]
Safety class
Figure 1
* Battery and Charger, sold sepa-rately
5
Operating Instructions
1. How to charge the battery
1) Insert the plug of the charger in the socket, and
the charging indicating lamp will be flickered in
green,red and yellow in turn within one second.
And then, the battery charger will be in the standby
position.
2) Insert the battery in the battery charger
considering the polarity, and the charging will be
started immediately.
A new battery will work properly after
five times of charging and discharging.
Charge and discharge the battery,
which is not used for a long time, for
two to three times to function well.
3) When the battery working time is remarkably
short despite full charging, the life of the battery
may be over. Replace the battery immediately.
Take care not to short-circuit the terminal
of the battery. The short-circuit of the
terminal may cause a fire or explosion
doing a serious personal injury.
2. Charging process
Use only the specified battery and
battery
charger.
and charger can be damaged by fire,
explosion,charging
Figure 2
1) Charging indication
Green Blinks : Before charging
Red Lights
: While charging
Green Lights : Charging completed
Red Blink
: Overheat standby
Yellow Blinks : Charging impossible
Be sure to unplug the charger after
finishing the charging.
2) If charging of the heated battery is attempted
immediately after it has been used or charged,
indicator blinks in red (overheat standby). After
50/60
14.4 - 18
3.0 ; 6.5
II
Otherwise
battery
error
or
overheat.
(Battery overheated)
Werbung
Inhaltsverzeichnis
