Snooze Function; Sleep Timer Operation - Hyundai RAC 481 PLLBO Bedienungsanleitung

PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM and 10 AM radio stations can be preset.
1. Follow steps in "RADIO OPERATION" and tune into the station that you wish to preset.
2. Press and hold SET for about 2 seconds, "P01" will flash on the display.
3. Press SET again to store the station.
4. Repeat steps 1 to 3 to store desired stations.
5. To listen to preset radio stations, press MEM repeatedly to select the
desired radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
SETTING ALARM 1 OR ALARM 2
1. In standby mode, press and hold AL1 or AL2 for 2 seconds.
• The hour and minute digits will flash.
2. Set the alarm time by repeatedly pressing HR and MIN respectively.
• Press and hold HR and MIN respectively for fast advance.
3. Press AL1 or AL2 again to select the alarm sound (OFF>BUZZER>RADO) in cycle.
CHECKING ALARM TIME
Press and hold AL1 or AL2 for 2 seconds, the alarm time will flash on the display.
To turn off the alarm, press POWER and the alarm will come on again at the set time on the
following days.
To cancel the alarm, repeatedly press AL1 or AL2 until the alarm indicator light goes out on
the display.

SNOOZE FUNCTION

This function can be used to stop the alarm temporarily for about 9 minutes once the alarm is
activated. When the snooze button is pressed, the buzzer or radio alarm sounds will stop and
sound again after about 9 minutes.

SLEEP TIMER OPERATION

The sleep function is designed to automatically turn off the Radio.
SETTING SLEEP TIMER
1. Press SLEEP.
• "90" will illuminate on the display.
2. Repeatedly press SLEEP to select the desired sleep time from 90, 80,
70, 60, 50, 40, 30, 20 or 10 minutes.
3. The radio will be turned off after the selected time has elapsed.
To check remaining sleep time, press SLEEP.
To cancel sleep timer, press SLEEP until "OFF" is selected.
To turn off the radio before the sleep time has elapsed, press POWER.
PROJECTOR
Switch on the projection clock with the Projection On/Off Selector (14).
Rotate : Scroll for setting the best projection clock viewing angle.
Focus Thumbwheel (15): Scroll for setting the best projection clock image.
EN - 22