Charging The Power Pack; Charging Devices - Hama PD20-HD Bedienungsanleitung

4. Operation

4.1. Charging the power pack

• Start the power pack charging process by connecting the enclosed USB-C to USB-C cable to the
USB-C input on the power pack (IN 5V/3A; 9V/2A) and to a suitable USB-C charger. Alternatively,
the power pack can also be charged via the micro-USB socket. To do this, connect a micro-USB
cable to the micro-USB input
(IN 5V/A; 9V/2A) on the power pack and a suitable USB charger. Consult the operating
instructions for the USB charger you are using.
• The charging process begins and ends automatically.
• Fully charge the power pack once before using it for the first time.
Note - capacity
• During the power pack charging process, the capacity is displayed constantly.
• Each status LED corresponds to 25% of the capacity. The permanent illumination of an LED
indicates that the capacity has already been reached. If three LEDs light up and the fourth one
flashes, the power pack is at least 75% charged.
• If all four status LEDs light up, the full capacity is available.
• Press the button on the power pack to switch this on and to determine the power pack's current
capacity.
• Press the button twice until the status LEDs go out to switch the power pack off.
Warning – rechargeable battery
• Do not charge the power pack via your PC or notebook. The charging currents can damage the
USB port on the PC or notebook.
• Only use suitable charging devices or USB connections to charge the product.
• Do not use defective chargers or USB ports and do not attempt to repair them.
• Do not overcharge the product or allow the battery to completely discharge.
• Avoid storing, charging and using in extreme temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
• Use the product only for the intended purpose.
• Do not use the product in the immediate vicinity of heaters, other heat sources or in direct
sunlight.
• Only use the article under moderate climatic conditions.
• Do not use the product in areas in which electronic products are not permitted.
• Do not attempt to service or repair the product yourself. Leave any and all service work to
qualified experts.
• Charge regularly (at least quarterly) during periods of prolonged storage.

4.2. Charging devices

• Connect the enclosed USB-C charging cable to the power pack's USB-C port (OUT 5V/3A; 9V/2A;
12V/1.5A - 18W PD) and the USB-C port on your device (mobile phone, smartphone, etc.).
• In certain circumstances, the enclosed charging / connecting cable may not match the USB port on
your device. In this case, use the USB cable that came with your device.
• When using the USB-A output (OUT 5V/2.4A; 9V/2A; 12V/1.5A - QC 3.0) for the charging
process, connect a suitable USB charging cable to the USB-A output on the power pack and the
port on your device.
• The charging process begins automatically. During the charging process, the status LEDs indicate
the power pack's remaining available capacity.
• The current battery charge status of your device is indicated on this.
• Terminate the charging process and switch the power pack off by pressing the button on the
power pack twice. The status LEDs go out.
• In the event that no device is connected, the power pack switches itself off automatically.
3