tell IP Bridge PRO Schnellinstallierungsanweisung Seite 8

8
External events: Up to 20 external events can be set in the module,
which are Contact ID events received on the simulated phone line. This
can be done with the Add more button at the bottom of the Events page.
The event settings are divided into 8 groups, and you can switch be-
tween them by the arrows in the header of the table.
Input properties
Input type: according to the wiring NO (normally open) or NC (normally
closed)
EOL: This option enables tamper protection on the given input.
Sensitivity (ms): The status change of the given zone input is ignored
if it is shorter than the value set here.
Bypass: Bypassed events are not generated.
Notify next: By selecting this checkbox the next event will be generat-
ed even if the CID code corresponds to this event.
Event codes
Each internal event can be associated with a Contact ID code, but the
CID code, partition and zone can also be modified.
Monitoring station settings
To report an event to a remote monitoring station, you need to En-
able reporting, and select the Server group that you want to report
the events Contact ID code to. Reporting to TMS should be enabled
separately.
E-mail settings
You can set up email notification about the events here. The recipient
list, subject and email body are editable by clicking the icon. To add
multiple addresses separate them by comma.
Camera settings
The cameras already added to the module can be assigned with the
events here. If an event occurs, the last 5 images recorded by the cam-
era which is assigned to the given event are sent via e-mail, or upload-
ed to FTP/SFTP server or forwarded to TMS.
VOIP (SIP) settings
V1-V4 columns indicate the phone numbers specified in the Voice call
section of VOIP menu. You can choose which of these you want to be
notified when the event occurs. In the Acknowledgement column you
can select the acknowledgement type (no ack/ with * button/ ack.
upon call reject). In each case, the reporting to other phone numbers