tell IP Bridge PRO Schnellinstallierungsanweisung Seite 2

COM: Common terminal between Z5 and Z6 contact inputs
Z6: 6. contactus input (considered between Z6 and COM)
TX:
RS232 serial port TX
RX: RS232 serial port RX
GND: RS232 serial port GND
V+:
Supply voltage 12-24V DC
V-: Supply voltage negative polarity (GND)
Connect the inputs accordingly to the configured control mode, nor-
mally open (N.O.) or normally closed (N.C.).
The device has 6 potential free, normally open (N.O.) relay contacts
(OUT1..OUT6 from left to right).
Attention! The maximum loads supported by the outputs is 1A @ 12V DC.
In case of higher load or higher voltage please use an external relay!
If the module has a 3G modem, use the 3G antenna connector to wire
the antenna.
Insert the SIM card into the socket until it clicks. To remove, press the
card again.
The module's network is configurable through the USB host.
Connect the local internet network cable (LAN) coming from the router
to the Ethernet connector of the IP Bridge.
-> Chapter 3 of the User manual
2