Micro CONDOR II Originalbetriebsanleitung Seite 11

WARNING
● As with any mechanical component, a vehicle is subject to high stresses and wear.
The various materials and components may react differently to wear or fatigue. If
the expected service life for a component has been exceeded, it may break suddenly,
therefore risking causing injuries to the user. Cracks, scratches and discoloration in the
areas subject to high stresses indicate that the component has exceeded its service life
and should be replaced.
● Do not modify the electric scooter or install incorrect accessories as this will put your
safety at risk.
● The use of unauthorized accessories may result in serious injury or damage to the
electric scooter.
● 'Customization' or 'Tuning' of the electric scooter is forbidden.
● Do not hang items such as bags on the handlebar, as this will have an adverse effect
on the handling characteristics.
● Incorrect tightening of screws may lead to material fatigue. Screws become soft
when they are subjected to excessive stress and may tear. This increases the risk of
accidents and injuries. Always use a torque spanner to tighten the screws.
● Self-locking fixings can lose their effectiveness after several months.Regularly check
the tightening of the various bolted elements, in particular the wheel axles, the folding
system, the steering system and the brake shaft.
● Always consult a specialist for repairs to the drive system.
● Make sure that the bearings are properly maintained at all times.
● The wheels may wear over time and should be replaced if necessary.
● Eliminate any sharp edges caused by use.
Please contact the official Micro distributor in your market for further information
regarding the followings:
● Lubrication recommendations: locations and frequency of lubrication,
recommended lubricant.
● The method for adjusting the brakes and recommendations concerning the
replacement of friction components.
● Method for adjusting or setting all of the components that would need to be
adjusted regularly or after replacement of a part.
● Where to find a qualified maintenance shop for items that cannot be done by oneself
(e.g. replacement of wear parts, electronic components, tightening torques etc.)
*NOISE EMISSION
● The A-weighted emission sound pressure level is less than 70 dB(A).
for setup, maintenance and repair
11