Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Assembly and installation
(Fig. 2)
Brightness control
Abbildung 1
1. If you want to install the motion detector into a round hole, place it in
the hole and tighten the spreader screws on both sides. If you want
to install the detector in a square hole, place the sensor in the hole
and fasten the screw through the installation hole. Reattach the front
panel, switch on the power and test it.
dung für Punkt 4
6. Switch-on duration setting options
Set the rotary knob with the lettering „Time" all the way to minimum (-). This is how you get the shortest
switching time (approx. 10 ± 3 seconds). If the knob is
turned to Maximum (+), you will get the longest switching
time (approx. 7 ± 2 minutes).
7. Brightness adjustment
g 3
Turn the rotary knob marked „LUX" all the way towards the sun
symbol. The detector now works during the day and night. When
set to the moon symbol, the detector only works at night. The
area in-between can be selected for various brightnesses.
8. Functional check
The motion detector requires a warm-up time of approx. approx.
30 seconds for full functionality with the initial commissioning.
Then the detector functions without a delay. Determine the
detection field in test mode (Turn both regulators to minimum and sun symbol) by doing a walk test.
The motion detector, triggered by movement, activates the connected consumer for the preset
switch-on time.
4008153045547_31184_BDA_A5_lang_0422.indd 7
4008153045547_31184_BDA_A5_lang_0422.indd 7
Abbildung für Punkt 4
Disconnect the power supply before carrying
out work on the motion detectors and check there
is no voltage with a voltage tester. Detach the front
panel of the sensor and set the time and brightness (LUX)
(Fig. 1) Loosen the screws in the connection terminal,
and then connect the power supply to the connection
terminal of the detector as shown in the connection
diagram (Fig. 2).
LUX
ON
PIR
Abbildung 2
Abbildung 4
Abbildung 3
Light sensor
Time adjustment
TIME
Operating LED
OFF
Switch
ON/OFF/
Movement
(Fig. 3)
BROWN
RED
Abbildung für Pun
BLUE
LOAD
~ IN
Abbildung 3
(Fig. 1)
Abbildung 1
Abbildung 2
(Fig. 4)
LUX
TIME
ON
OFF
PIR
Abbildung 4
7
29.04.22 08:38
29.04.22 08:38
Werbung
Inhaltsverzeichnis
