Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.
The final step is to put the nuts on both sides and tighten the wheel to the bike
frame.
NOTE: Make sure the washers are correctly installed and the wheel nuts in the fork and
frame are tightened.
SADDLE MOUNTING AND ADJUSTMENT
4
1.
Tilt the saddle clamp handle (Fig. 4.1).
2.
Place the bar with the saddle in the bike frame (Fig. 4.2).
3.
Adjust the saddle height to suit your child's height.
4.
Tighten the clamp nut carefully and tighten the bracket to secure the saddle (Fig.
4.3).
NOTE: When adjusting the saddle, pay attention to the maximum safe height of the
saddle. The maximum height marking on the saddle bar must not be above the clamp.
CLEANING AND MAINTENANCE
•
Clean the bike with a soap and water solution with the use of a damp towel with that
•
said solution.
•
Do not use strong detergents to clean the product.
•
Before using the bike, make sure all screws are correctly tightened.
•
Use a silicone-based grease for moving parts. Use it only when its use is absolutely
•
necessary.
•
In the event of the excess of grease, remove it from the product with a clean cloth.
•
To avoid friction of moving parts, which can damage the bike, make sure they are
•
clean. Any remains of sand, dirt or dust might cause them not to work properly.
•
When the product is not in use, it should be stored in a room free of moisture and
•
away from too high temperatures.
•
If replacement of individual elements is necessary, original parts or those approved
•
by the manufacturer must be used.
•
Frequent use of adjusting parts wears them out. When the components lose their
•
properties, they should be replaced as soon as possible.
•
Disassembling of the bike takes place in the reverse order of assembly.
ENVIRONMENT
For environmental reasons, we kindly ask of the disposal of this product at a specifically
for this purpose designed disposal site which is in accordance with local legislations.
LIMITATIONS OF WARRANTY
The warranty does not cover destruction or loss of individual elements due to falling,
abrasion, incorrect assembly and use which is not in accordance with the user manual.
12
MAX
35kg
Werbung
Inhaltsverzeichnis
