Klarstein BOTELLA 300S Bedienungsanleitung Seite 24

EN
24
Loading the Wine Cellar
• You may load your wine bottles in single or double rows while taking note of the
following: if you do not have enough bottles to fill your wine cellar, it is better to
distribute the load throughout the wine cellar so as to avoid "all on top" or "all
below" type loads.
• Do remove or relocate adjustable wooden shelves to accommodate larger type
of bottles or increase the capacity of the cellar by stacking the bottles up when
necessary. (See removing shelves)
• Keep smalls gap between the walls and the bottles to allow air circulation. Like an
underground cellar air circulation is important to prevent mould and for a better
homogeneous temperature within the cellar.
• Do not over load your wine cellar to facilitate air circulation.
• Avoid obstructing the internal fans (located inside on the back panel of the wine
cellar).
• Do not slide the shelves outwards beyond the fixed position to prevent the bottles
from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the wine
cellar to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct
air circulation.
• Do not move your wine cellar while it is loaded with wines. This might distort the
body of the wine cellar and cause back injury.
Control Panels and Controls
The LED displays by default the actual internal air temperature. In the event of a power
interruption, all previ- ous temperature settings are automatically erased and it will revert
to the preset temperature settings.
Single Window Display Board
1. Window: Display shows the actual
temperature.
2. Cycle Button: Press one time ,the
inside temperature will reduce 1
degree Celsius,until down to the
lowest,press one time,the tempe-
rature will back to the highest.
3. Press the button 3 seconds to power
off or power on. Press the button and
the lamp turns on, the lamp will turn
off once press again.