Werbung
Use the table to select the appropriate darkening level. Depending on personal
feelings, the next higher or lower protection level can be used.
Arc Current (Ampere)
Welding
Processren
SMAW welding with coated electrodes
MAG MAG welding
TIG tungsten inert gas welding
MIG (heavy) MIG welding of heavy metals
MIG (light) MIG welding of light alloys
PAC plasma cutting
PAW plasma welding
"Grind" Function
Left stop of the setting button (1), darkening when switched off, suitable to
protect you from the light of a spark from an angle grinder.
Operation
Turn the darkening adjustment knob (1) to the setting required for the
respective work (see table above).
The self-test button (6), the slide switch (12) for switching the LED (14) on and
off, the adjustment buttons for delay (8) and sensitivity (10), the battery
warning light (11) are located on the darkening filter cassette ) and the battery
compartment (7).
Setting Delay
After the end of welding, the viewing window automatically changes from dark
back to light, but with a preset delay to compensate. The delay time can be set
to MIN (0.1 sec.) Or MAX (1.0 sec.) With the rotary knob (8). The minimum
delay is suitable for spot or short welds. The maximum delay is suitable for
high-voltage welding and reduces eye fatigue from the arc. The selection range
between MIN and MAX is suitable for most indoor and outdoor welding work.
Setting Sensitivity
The sensitivity can be set to LOW or HIGH by using the dial knob (10). The LOW
setting is suitable for excess ambient light or with another active welding
machine close by. The HIGH setting is suitable for low amperage welding and
welding in areas with low light conditions, especially low amperage argon arc
13
Werbung
