pasapair OL20-BD030BM Bedienungsanleitung Seite 18

①Fan is on low
②Fan is on high
③Sleep indicator
④Reset indicator
⑤Lock indicator
ON/OFF
In the standby state, press the ON/OFF button to turn on, the operation
indicator lights up and the default fan speed is high, the LED shows
ambient humidity. Pressing the power button again will power the unit
off, the running indicator light goes off and the compressor stops
immediately, and then the fan will stop operating after a short delay.
MODE: Press this to cycle through Auto Mode / Continuous Drying
Mode.
● Auto mode: Both fan speed and humidity can be adjusted in this
mode.
When the room humidity is 3% (and more) higher than the selected
humidity the fan and compressor will begin to operate after 3 seconds.
When the room humidity is 3% (and more) below the set humidity the
compressor and the fan will stop operating after a short delay.
● Continuously drying mode: The humidity is not adjustable in this
mode.The unit will run continuously.
SLEEP/RESET: Touch this button, the button lights up and start the
SLEEP function. Press again the button to RESET the appliance.
⑥Tank Full indicator
⑦Timer indicator
⑧Auto mode
⑨Continuously drying mode
⑩Power on
14