Charging Up The Battery - Cleanmaxx 05249 Gebrauchsanleitung

EN
WARNING – Danger of Fire!
■
Do not charge up the device in the
vicinity of highly flammable materials
(curtains, textiles, etc.).
■
Do not operate the device on hot
surfaces or close to a flame.
■
Do not cover the device during oper­
ation or charging in order to prevent
it from catching fire.
NOTICE – Risk of Damage to
Material and Property
■
Charge and store the device only in
closed rooms.
■
Use only original accessories from the
manufacturer in order to guarantee
that there is no interference that may
prevent the device from working and
to avoid possible damage.
■
Do not place heavy objects on the
device or the charger cable.
■
Make sure that the charger cable is
not squashed, bent or laid over sharp
edges and does not come into con­
tact with hot surfaces. Do not wind
the charger cable around the power
supply.
■
When you pull the power supply out
of the plug socket, always pull on the
power supply and never the mains
cable!
■
Protect the device from impacts.
CHARGING UP THE
BATTERY
Please Note!
■
Do not charge up on a computer
because the computer might be dam­
aged by the high charging current.
To connect the device to the plug
socket, a USB mains adapter (5 V DC
and max. 2 A; not supplied with the
device) is required.
14
■
Only connect the mains adapter to a
plug socket that is properly installed
and matches its technical data. The
plug socket must be readily acces­
sible after connection so that the
connection to the mains can quickly
be isolated.
■
Only use suitable extension cables
whose technical data is the same as
that of the power supply.
■
Pull the power supply out of the plug
socket if an error occurs during charg­
ing or before a thunderstorm.
■
It is essential that you charge up the
battery fully before you first use the
device in order to achieve the maxi­
mum charging capacity.
L
The charging process takes
approx. 4 hours.
If the device cannot be switched on
or a single bar of the charge control
lamp flashes, the battery is too weak and
needs to be charged.
1. Open the closure of the charging
socket (17) and plug the charger
cable (5) into the charging socket
(Picture C).
2. Connect the other end of the charger
cable to a power source with a USB
interface (preferably via a USB mains
adapter to the plug socket).
The charge control lamp (16) flashes
and the charging process starts.
When the battery is fully charged, all
the bars of the charge control lamp
light up.
3. Disconnect the charger cable from
the power source and then from the
charging socket.
4. Seal the closure again.