Problem Solving - KLAMER Black Serie Milk Frother Pro Bedienungsanleitung

Cleaning
Please always disconnect the device from the power source before cleaning
or moving it. You clean the milk frother as follows:
1. Allow the milk container to cool down before cleaning it.
2. Empty the milk container if there is still liquid in it.
3. Remove the frothing or mixing attachment by pulling it off with your
fingers.
4. Clean the frothing or mixing attachment under running water.
5. Rinse the milk container with warm water and dishwashing detergent.
Clean it with a soft cloth so as not to damage the non-stick coating.
6. Remove the lid rubber by grasping it in the area of the pouring gap and
pulling it off. Clean the lid and lid rubber with warm water and dishwashing
detergent. Dry the lid and lid rubber with a soft cloth to avoid scratching the
surfaces. Attach the lid rubber to the lid.
7. Wipe the surface of the unit and the control element with a soft cloth
slightly moistened with water.
Important
Do not use abrasive cleaners or sharp objects to clean the milk container and
housing, as they may damage the surfaces.
Note
The attachments and the lid can be cleaned in the dishwasher at any temperature.
The milk container may be cleaned in the dishwasher as well, but the temperature
may not exceed 70° C.
Storage
1. First disconnect the power plug from the socket.
2. Store the device in a dry, dust-free and frost-free place without direct
sunlight exposure.
3. Make sure that the device is stored out of the reach of children.
4. To avoid damage during transport, we recommend that you use the
original packaging.
17

Problem solving

Problem Possible cause
The milk frother does not The power plug is not
work connected to a power outlet
The process is aborted even Milk container is empty. The
dry boil protection has been
though the milk or foam
does not yet have the triggered automatically
expected consistency or
temperature
The wrong attachment was
used, which prevents the
formation of foam
The milk or the milk foam There is too much milk in
flows out of the milk the milk container
container
The device generates Due to the motor as well as
the oscillating movements
operating noise during use
of the contents, the device
may cause slight operating
noises from time to time
Not all of the milk is frothed
Milk does not get hot
enough
Solution
Connect the power plug to
the power supply
Remove the milk container
from the base and allow it to
cool down. Fill it sufficiently
and start the process again.
Use the frothing attachment
and start the process again
Observe the max. filling
quantity and use the lid if
necessary
This is completely normal
and does not lead to a
defect of the device. You do
not need to do anything.
This is perfectly normal
depending on the program
selected and the amount of
milk. Use the remaining milk
to prepare your beverage
The max. temperature is
65°C. Higher temperatures
cannot be achieved with this
device
18