Zeegma Knapper Grand Bedienungsanleitung Seite 5

5.
Check that the total current consumption of all devices
connected to the wall socket does not exceed the maximum
load of the fuse.
6.
If an extension cable is used, check that the total power
consumption of the equipment connected to the extension
cable does not exceed the load parameters of the extension
cable. The extension cable should be arranged in such a way
as to avoid accidental pulls and tripping over it.
7.
Do not let the device's power cable hang over the edge of
a table or shelf or touch a hot surface.
8.
The device is not intended to be controlled by an external timer,
a separate remote control or other equipment that can switch
the device on automatically.
9.
Always disconnect the device from the power supply before
maintenance work.
10. When disconnecting the power cable, always pull it out of the
socket by holding the plug. Never pull out the power cable by
pulling on the cable, as the plug or cable may be damaged, in
extreme cases an electric shock may result.
11. The device must not be left unattended when plugged in.
12. Do not immerse the device in water or any other liquid. The
device cannot be cleaned under a direct stream of water.
13. The device should be cleaned regularly according to the
recommendations described in the section on Cleaning and
maintenance of the device.
14. Do not place the device close to heat sources, flames, an electric
heating element or a hot oven or on top of any other device.
15. Special care should be taken when using the device when
children or pets are around. Children should not be allowed
to play with the device.
16. Do not expose the device to weather conditions (rain, sun, etc.)
or use it in humid conditions (e.g. in the bathroom).
17. Periodically check the condition of the power cable. If the
power cable becomes damaged, it should be replaced at the
manufacturer's authorised service centre to avoid any danger.
18. Do not use the device with a damaged power cable or plug or
if it has been dropped or damaged in any other way or is not
working properly. Do not repair the device yourself, as there is
a risk of electric shock. Take the defective device to a competent
EN