Assembly (Fig. 2-4); Start-Up - Scheppach 5907802901 Originalbetriebsanleitung

h) If the power tool falls into the material to be
mixed, unplug the power tool immediately and
have the power tool checked by a qualified re-
pair person. Reaching into the mixing container
with the power tool still plugged in can lead to elec-
tric shock.
i) Do not reach into the mixing container with
your hands or insert any other objects into it
while mixing. Contact with the stirrer may lead to
serious personal injury.
j) Start up and run down the power tool in the
mixing container only. The stirrer may bend or
spin in an uncontrolled manner.
Residual risks
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks can-
not be rules out. The following hazards may arise
in connection with the equipment's construction
and layout:
• Lung damage if no suitable protective dust mask
is used.
• Damage to hearing if no suitable ear protection is
used.
• Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.

6. Assembly (Fig. 2-4)

Chucking the beaters
Risk of injury! Wear protective gloves.
• The beater holders (9/10) and the beaters them-
selves are identified by the letters R and L.
• Push the sleeve (11/12) down and connect the
beaters (2/3) to the appropriately identified hold-
ers (9/10).
Make sure that the pin (a) is in the groove (b) on
each beater.
• Release the sleeve. The beater is locked.
m Check the safe seating of the beaters by pulling
on them.
7.

Start-up

Before you connect the equipment to the mains supply
make sure that the data on the rating plate are identi-
cal to the mains data.
Always pull the power plug before making adjustments
to the equipment.
Switching on/off
Do not use any device where the switch can not
be switched on and off. Damaged switches must
be repaired or replaced immediately by the cus-
tomer service.
Switching on (Fig.5)
• Operate the trip switch (5) at first. Press the ON/
OFF button (4) on the handle.
Start the machine at the lowest rotational speed
(Level 1).
Switching off
• Release the ON/OFF handle button.
This machine is not suited for continuous oper-
ation.
Speed control (Fig. 6)
With this type, the motor's speed and thus the agitator
performance can be adjusted. (Level 1 - 6).
• You can continuously adjust the speed with the
speed control (6).
2- speed gear (Fig. 7)
The device is equipped with a 2-speed gear. If the
gear selection switch cannot be locked, turn the stir-
ring staff a little.
• For the speed selection turn the switch (7) by 180°.
1. speed: 0 min
2. speed: 0 min
Only operate this switch at standstill.
Working with the paint and mortar mixing tool
Before changing the mixing tool you must pull the pow-
er plug.
Reduce the working speed when you immerse the mix-
ing tool into the material you want to mix and when
you take it out again. When the mixing tool is fully im-
mersed, raise the speed to maximum in order to en-
sure adequate cooling of the motor. Move the mixing
tool through the mixing container during the mixing
operation. Continue mixing until all the material has
been thoroughly processed. When you are finished
with your mixing work, clean the mixing tool.
www.scheppach.com
- 450 min
–1 –1
- 790 min
-1 -1
GB | 21