Example Of Automatic Data Logger Mode; Example Of Manual Data Logger Mode; Example Of Printing A Value - XS Instruments VioLab 60 Serie Betriebsanleitung

P8.4 Print format
Access this menu to select the information to print in the header of a Data Logger on a printer:
SIMPLE: -default setting- The device model, Serial Number and date and time of the last calibration are

printed in the header.
COMPLETE: In addition to the information of the SIMPLE format, the calibration data are also printed

(available in the "CALIBRATION DATA" setup menus).
Note: The header is printed in the following cases:
 When a printout of values for a certain parameter is started for the first time.
 When a new calibration is performed.
 Example of automatic Data Logger mode
Example: automatic pH recording on internal memory every 2 minutes
Access the LOG SETTING P8.0 setup menu.

Enter the LOG TYPE P8.1 menu, press

 Use the directional keys to change the number that flashes on the display. Enter "2" and confirm with
.
 Go back to measure mode and go to the pH screen
The icon is lit in the lower string of the display, which indicates that an automatic frequency Data
Logger has been set.
 Press to start recording; the icon
The number next to the M+ icon indicates how much data has been saved for that parameter.
Press again to end the recording.

Note: automatic recording is suspended when the measurement parameter is changed.
 Example of manual Data Logger mode
Example: recording a Conductivity value in manual mode
Access the LOG SETTING P8.0 setup menu.

 Enter the LOG TYPE P8.1 menu, press key
Confirm with and return to measure mode, go to the COND screen

 Press to save the value. The number next to the M+ icon indicates how much data has been
saved for that parameter.
Note: Manual or automatic saving of a value is confirmed by a sequence of flashes of the green LED.
 Example of printing a value
Example: manual printing of a pH value with calibration data too
 Access the LOG SETTING P8.0 setup menu.
Enter the LOG TYPE P8.1 menu, press

Confirm with .
Enter the SAVE DATA P8.3 menu, press

Confirm with .
 Enter the PRINT FORMAT P8.4 menu, press
Confirm with and return to measure mode, go to the pH screen

Press to print the calibration data and the value in GLP format.

Note: The values saved in the instrumental memory CANNOT be printed, only exported to PC.
UM Serie 60VioLab rev.0 20.05.2020
and move with directional keys to MINUTES.
.
starts flashing, indicating that the storage is in progress.
and move with the directional keys to MANUAL.
and move with the directional keys to MANUAL.
and move with the directional keys to PRINTER.
and move with the arrow keys to COMPLETE.
31
.
.
EN