Example Of Automatic Data Logger Mode; Example Of Manual Data Logger Mode - XS Instruments OXY 70 Vio Serie Betriebsanleitung

• Move with the keys
The table below shows the setup menu structure for the Data Logger mode; for each program, there are
the options that the user can choose and the default value:
Program Description
P8.1 TYPE OF SAVING
P8.2 EMPTY INTERNAL MEMORY
P8.1 Registration type
Access this menu to select the data acquisition mode:
MANUAL: The data is acquired only when the user presses the button
•
HOURS - MINUTES: Set an automatic data acquisition frequency range.
•
Use the directional keys to move from MANUAL to HOURS or MINUTES. Access with
indicated by the icon
.
Use of automatic Data Logger
•
In measure mode press
When the automatic data saving is running, the icon
When it is set, but not in operation, the icon on the screen remains fixed. When the 1000 total values
are reached, the recording stops automatically.
Note: Scrolling through the parameters, the recording stops.
P8.2 Memory emptying
Access this menu and select YES to clear the saved data and empty the memory.
Next to the M+ icon. It shown the total number of data stored.

• Example of automatic Data Logger mode

Example: automatic pH recording on internal memory every 2 minutes
Access the LOG SETTING P8.0 setup menu.
•
Enter the LOG TYPE P8.1 menu, press
•
Use the directional keys to change the number that flashes on the display. Enter "2" and confirm with
•
. Go back to measure mode.
The icon is lit in the lower string of the display, which indicates that an automatic frequency Data
Logger has been set.
• Press to start recording; the icon
The number next to the M+ icon indicates how much data has been saved for that parameter.
• Press again to end the recording.
Note: automatic recording is suspended when the measurement parameter is changed.

• Example of manual Data Logger mode

Example: recording a Conductivity value in manual mode
Access the LOG SETTING P8.0 setup menu.
•
• Enter the LOG TYPE P8.1 menu, press key
UM Serie Oxy70Vio EN rev.0 28.05.2020
and to select the program to access.
MANUAL – HOURS - MINUTES
YES – NO
, change the value of the acquisition time. Confirm the setting with the key
to start and end automatic recording.
and move with directional keys to MINUTES.
starts flashing, indicating that the storage is in progress.
and move with the directional keys to MANUAL.
19
Options Factory Default Settings
.
flashes on the display.
EN
MANUAL
-
and, as