Problems And Solutions - EUROM GE2501 Bedienungsanleitung

 Undo the spark plug using a plug spanner and remove the carbon deposits from the
plug.
 Measure the space between the electrodes: they should be 0.7 to 0.8 mm.
 Secure the spark plug and replace the cap.
Maintaining fuel filter
 Turn the fuel tap to OFF (closed) and take the fuel filter out of the tank opening.
 Thoroughly clean the filter.
 Secure a new rubber washer to the filter and replace carefully back into the opening.
Storage
If the generator is to be stored for a long period, you must take the following measures:
1. Undo the fuel drainage cap and let the fuel run out of the carburettor.
2. Undo the drainage plug and let the oil run out of the crank case.
3. Replace the oil drainage plug.
4. Fill the generator with oil to the upper mark on the dipstick.
5. Pull the starter rope out until you feel resistance.

Problems and solutions

The engine fails to start
 Too little fuel: check and fill if necessary.
 The start/stop switch is not set to ON: switch to on.
 Too little oil: check and fill if necessary.
 The speed and/or power with which you pull the cord is insufficient: pull the cord
forcefully.
 The spark plug is contaminated with carbon: check and clean.
The generator is not supplying power
 The start/stop switch is not set properly: set it to ON.
 The socket is not connected properly: check. If you discover any irregularities, consult a
supplier or qualified electrician to check/repair the device.
 The generator will not achieve the correct revolutions because it is heavily loaded:
disconnect some of the devices and try again.
Disposal
At its end of life, discard the device according to the local laws and regulations, or deliver
the device to your supplier.
Attachments
An overview of possible uses and the EU Declaration of Conformity can be found at the
end of this manual.
26