Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Connect the power cable
a. Open the inner plastic panel and remove it from the hatch or tailgate. (The panels are usually attached
to the tailgate by clips. This may take a bit longer time to avoid clip damages. Once this panel is
removed, the work will be done easily.)
b. Find the power wire (positive) of the reversing light and connect it to the red wire of the power cable.
Then connect the black wire of the power cable to the ground (Iron part of the vehicle).
3. Install the backup camera
Step1: Look for an opening or drill a hole with the hole saw to thread the camera cable into the interior of
the vehicle.
Step2: Then remove the bracket from the camera. The screws need to be kept in a safe place to avoid
losing them.
Thread hole
Screw hole
Step1
2
Waterproof plug
+ 12V-24V Reversing light power wire
Ground (iron part of the vehicle)
Step2
Werbung
Inhaltsverzeichnis
