Magmaweld ID 65 PX Bedienungsanleitung Seite 30

30 Maintenance and Service
E14
Error Code
EN
E15
E16
E17
E18
E19
E20
E21
E22
E23
E26
E27
E28
E29
E30
E31
USER MANUAL
System Error • There may be a hardware error
Error
Remote Control
• There may be an error in the remote
Communication
control connections
Error
System Error • There may be a hardware error
• The uptime of your machine may have
been exceeded
• Fan may not be working
Thermal
Protection
(Secondary)
• The front of the air inlet - outlet ducts
may be blocked
• The machine working environment
may be too hot or stuffy
System Error • There may be a hardware error
Inlet Pressure
• Inlet pressure may be low
Low
Torch Shield Not • Torch shield may not be installed or
Installed properly fitted
System Error • There may be a hardware error
DC Busbar
• Mains voltage may have decreased
Voltage Low
DC Busbar
• Mains voltage may have increased
Voltage High
System Error • There may be a hardware error
• Contact the authorized service
Cause
• Check remote control connections
• If the problem continues, contact the
• Contact the authorized service
• Allow the machine to cool down by
• If the problem continues, contact the
• Visually check if the fan is working
• If the problem continues, contact the
• Unblock the front of the air ducts
• If the problem continues, contact the
• Make sure that the working
• If the problem continues, contact the
• Contact the authorized service
• Check your air / gas connections,
• Make sure that the torch shield is
correctly fitted to the machine
• If the problem continues, contact the
• Contact the authorized service
• Check the mains connection cables
• Check the mains connection cables
• Contact the authorized service
ID 65 PX / ID 65 P
Solution
authorized service
waiting for a while. If the fault
disappears, try to use the machine at
lower amperage values
authorized service
authorized service
authorized service
environment of the machine is not
excessively hot or stuffy
authorized service
make sure that the inlet pressure
is appropriate. If the inlet pressure is
normal, contact the authorized
service
authorized service
and the voltage. Make sure the
correct voltage input is providevd.
If the mains voltage is normal,
contact the authorized service
and the voltage. Make sure the
correct voltage input is provided.
If the mains voltage is normal,
contact the authorized service
www.magmaweld.com