Adjusting Height Of Brush; Adjusting Brush Angle; Adjusting Handlebars Height - Texas A/S Smart Sweep 800 Bedienungsanleitung

Stopping the engine:
1. Set the throttle handle to minimum/stop.
2. Close the fuel cock.
Choke
Run
STOP
–
Clutch Handle 1 Forward and
Back:
To operate the black handle 1 in Fig.
8, pull the handle down and the
sweeper will move forwards or
backwards. To change direction,
release the grip and put the gear
selector into the desired direction and
activate the handle again.
–
Clutch handle 2 activating
brushes:
To operate the black handle 2 in Fig.
8, pull the handle down and the
brushes will activate.
Grip for brush speed 3
brush speed:
Push the handle forward and increase
the rpm of the brushes. When the
handle is pulled back, the rpm is
reduced. Press down the locking button
on the handle to be able to pull the
handle back.
modello effettivo può variano dall'illustrazione mostrata - Il modello effettivo può variare dalle illustrazioni mostrate
Ihr Modello Kann von der Abbildung abweichen - Tuo modello attuale puo essere diverso dalle illustrazioni
–
Regulating
–
Throttle grip 4
To activate the throttle handle, push the
handle forward.
Operation safety zone.
The operator may not leave the operation area marked
in Figure 10 when operating the machine. During
operation, should the operator needs to leave the
safety zone, for example to adjust the brush height or
secure an accessory, he or she must first stop the
engine.

Adjusting height of brush

When the brushes start to wear, it is necessary to
adjust how close the brushes are to the ground. To
adjust the height of the brush, adjust up or down the
rotary handle above the brush, until the desired
position is achieved.
See Figure 9.
1. Loosen the contra nut (1).
2. Screw the adjusting handle (2) up or down to the
desired position.
3. Tighten the contra nut (1) to secure the adjustment
handle in position.

Adjusting brush angle

The brush can be turned 25 degrees to each side. Do
this by pushing the brush angle support rod on the
sweeper down, turning the brush and releasing the
handle, so that the pawl clicks into place.

Adjusting handlebars height

Adjust the handlebars, so that the
working height is optimal. Adjust the
handle on the underside of the
handlebars. Figure 2, D
17
setting engine rpm: