Decommissioning; Decommissioning The Device - Sartorius Flexsafe Pro Mixer Drive Unit Betriebsanleitung

1
11

Decommissioning

11.1

Decommissioning the Device

Requirements
The device is removed from the Palletank
Mixing Process", page 45).
Procedure
Turn the device off.
t
Disconnect the power supply cable from the power supply at the instal-
t
lation site.
Disconnect the potential equalization cable from the power supply at
t
the installation site.
Unscrew the nut for the strain relief (1).
t
Remove the power supply cable from the cable holder.
t
Screw in the nut for the strain relief.
t
Remove the potential equalization cable from the "Potential
t
equalization" connection.
If the device is connected to a remote control: Remove the connection
t
cable and seal the connection with the locking cover cap.
CAUTION Risk of injury due to uncontrolled rolling away of the
t
device! Place it on a level surface and secure the brakes. Wear personal
protective equipment.
Operating Instructions Flexsafe
Decommissioning
(see Chapter "8.12 Ending the
®
Pro Mixer Drive Unit
®
53