Button Description - RUSTA Kettle Gebrauchsanweisung

BUTTON DESCRIPTION

This is a multifunctional
button, and works as a 100°C
button, power button or keep
warm button.
BEFORE USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that you should clean your
kettle first. Boil a full kettle of water twice, and then discard the water. Note that the max
capacity of the kettle is 1,7 liters.
USING YOUR KETTLE
1. To fill the kettle, remove it from the power base and open the lid by pressing the
release button. Fill it with your desired amount of mater, and then close the lid. The
kettle may also be filled through the spout. The water level should not exceed the MAX
mark, or sit below MIN mark. Too little water will result in the kettle switching off.
2. Put the kettle on to the power base and connect the plug into a power outlet. The
power base can be rotated 360°.
3. To start boiling, press the "100°C" button once. The kettle will heat up the water to
100°C. when the water temperature reaches 100°C, the indicator will turn off and you
will hear two beeps.
4. If you want to select another water temperature, press the "+/-"button and select
your desired temperature. Then press the "100°C" button to start the kettle. When
the water has reached your desired temperature, the indicators will turn off and two
beeps can be heard.
5. If you want to use the keep warm-function, press the "+/-"button and select your
desired keep warm temperature. After selection, its corresponding indicator will light
up. Hold and press the "100°C" button for 3 seconds, and the kettle will enter the keep
warm mode. After heating up to your desired temperature and keep your water in the
right temperature. One beep can be heard when the keep warm function has been
started. After 30 minutes, the kettle will shut off automatically.
NOTE! Make sure that the switch is free of obstructions and that the lid is firmly closed.
This button is used to select
your desired temperature:
50°C/70°C/80°C/90°C.
5