JBM 52600 Bedienungsanleitung Seite 7

ILLUSTRATION OF THE SCREEN AND THE LED LIGHT
Single-phase
Three-phase
Home screen
Wait for the plug to be
inserted.
Connect the charging connector
Wait for identification
Press the button
Wait until the car is
ready
WAITING
During the charging
process
Stop charging and
wait to remove the
plug
00:10:00
1. Real-time current
2. Real-time voltage
3. Power consumed
4. Temperature
5. Charging icon
6. Charging time
7. Rated current
1. Cause of failure
2. Temperature
3. Fault icon
4. Automatic reset
EV AC Charger
22.8ºC
22.8ºC
22.8ºC
23.7ºC
Disconnect the charging
connector
0.00Kwh 22.8ºC
· 7 ·
LED status instructions
Rest
Connected
Charging
Finished
Error
NOTES:
When small problems like short-circuit occur, the wall charger
will automatically restart to repair and continue charging. In the
case of serious faults, the system cannot recover automatically.
In order to remind the user of this fault, after the user discon-
nects the plug, the system will countdown 10 seconds to restart.
MAINTENANCE
• To ensure the normal service life of the charging station
and to reduce risks, maintenance must be carried out on
schedule.
• Maintenance of the equipment must be carried out by
professionals with qualified and safe maintenance tools.
• The product is already packed at the factory. During
transport, strong impacts and shocks should be avoided
so as not to damage the outer packaging of the product.
• The product should be placed at an ambient temperature
of -25°C~55°C with relative humidity not exceeding 95%.
The air must not contain acids, alkalis or other corrosive
gases and explosive gases.
1. Real-time power
2. Three-wire live data
3. Charging time
4. Power consumption
5. Charging icon
6. PCB temperature
- Emergency stop
- Overtemperature
- Overcurrent
- Leakage protection
- Short-circuit
OFF
Continuous light
Rolling
Continuous light
Red flashing