JBM 52600 Bedienungsanleitung Seite 6

INSTALLATION GUIDE
1
Stick the drilling reference paper on
the wall where you want to mount
the wall charger.
Pared
Perfore los agujeros de
Drill the holes according to the re-
acuerdo con el papel de
ference paper.
referencia.
You will need: 1* electric drill,
Necesitará: 1* taladro eléctrico,
1* M5 bit (for charger), 1* M6 bit
1* broca M5 (para el cargador),
(for socket)
1* broca M6 (para la toma de
corriente)
2
Martilla los pernos
de plástico de 30
Hammer the 30 mm plastic
mm en los agujeros.
bolts into the holes.
Martilla los pernos
Hammer the 30 mm metal
metálicos de 30 mm
bolts into the holes.
en los agujeros.
A continuación, retire
Then remove the reference
el papel de referencia
paper from the wall.
de la pared.
3
Fije la placa B con los
Fix the plate B with the 30
tornillos de 30 mm en
mm screws on the wall.
la pared.
Then fix the plate A with M5
A continuación, fije la
screws to the back side of
placa A con tornillos M5
the station.
en la parte trasera de la
estación.
4
Embed the plate A with wall
charger on the plate B.
5
Take out the plate from the
body of charging socket.
Wall
6
Fix the socket to the wall
using the 95 mm screws
with Allen key and put back
the plate back on the soc-
ket.
95 mm screws
7
Connect each wire with
Conecte correctamente
the power supply correctly.
cada cable con la fuente
de alimentación.
Fix the hook with four plas-
tic bolts.
Fije el gancho con
cuatro pernos
plástico.
The cable can be hung on
El cable puede colgarse
the hook.
en el gancho.
8
Tear off the protector.
INSTRUCTION FOR USE
NOTE: Hang the cable on the hook when it is not in use.
Make sure the wall charger is con-
nected to the power supply.
Insert the plug into the socket.
Connect the electric vehicle and the
wall charger with the electric vehicle
charging cable.
Press the button on the right side
of the wall charger to start or stop
charging.
· 6 ·
Screw
de