Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
INSTRUCTION MANUAL
PRODUCT DESCRIPTION
This wall charger for electric cars can be installed in a garage
or anywhere in your home. With built-in overcurrent and leaka-
ge protection, it can be installed as a stand-alone unit to ensure
your safety.
GENERAL SAFETY INSTRUCTIONS
WARNING! Read all safety warnings and all instructions.
Failure to follow the warnings and instructions listed below may
result in electric shock, fire and/or serious injury.
•
Check the charging station regularly for visible dama-
ge. An electric shock may occur when using a broken
charging station, therefore a damaged product should
not be used.
•
Make sure that all safety facilities are available at all
times and test them regularly to ensure that they can
function normally.
•
If a ground fault occurs, it must be assumed that the
cable carries voltage. Confirm that there is no voltage
power in the system before inspecting the charging
station.
•
Before switching on the device, confirm that it is properly
grounded to avoid unnecessary accidents.
•
All unnecessarily exposed metal parts of tools must be
insulated to prevent them from coming into contact with
the metal frame to avoid short circuits.
•
Keep the power cord away from the heated surface. Do
not place the power cord in the opening of the closed
door or away from sharp edges or corners.
•
Do not use the charger when the inside of the charging
plug is wet.
•
Do not modify, retrofit or change any parts yourself un-
der any circumstances.
•
To ensure the service life and stable operation of the
charging station, the operating environment should be
kept as clean as possible with relatively stable tempe-
rature and humidity.
•
The charging station must not be used in flammable en-
vironment or volatile gas environments.
•
Make sure that the input voltage, frequency, circuit
breakers and other conditions of the device meet the
specifications before powering it up.
•
The circuit to which the charger is to be connected must
be equipped with a residual current circuit breaker.
•
Do not use this product as a toy and keep children and
bystanders away from it.
•
Do not use it for any purpose other than charging the
electric car.
•
Do not attempt to disassemble the device by yourself
under any circumstances. Otherwise, the internal preci-
sion parts may be damaged and you will not be able to
apply after-sales services.
TECHNICAL SPECIFICATIONS
Reference
Phase mode
Socket type
IP rating
Max. output power
Max. output
current
Size
Weight
Working tempe-
rature
PARTS LIST
1.
Display screen
10. 30 mm plastic bolts (x10)
2.
LED light
11. 30 mm screws (x10)
3.
ON/OFF key
12. Screw shim (x4)
4.
Socket
13. 30 mm metal bolts (x4)
5.
Single-phase
14. Allen key
6.
Three-phase
15. 95 mm screws (x4)
7.
Station
16. M5 screws
8.
Plate A
17. Hook
9.
Plate B
18. Reference paper
5
6
8
9
16
17
14
· 5 ·
52600/52902
52903/54052
Single-phase
Three-phase
Type 2
Type 2
IP66
IP66
3.6KW/7.5KW
11KW/22KW
16A/32A
16A/32A
295x195x70mm
295x195x70mm
6.69kg
6.69kg
-25ºC ~ +55ºC
-25ºC ~ +55ºC
1
2
4
15
4
5
12
3
11
13
10
18
Werbung
