Livall EVO21 Benutzerhandbuch Seite 6

2) Replacing device (When the original BR80 lost or damaged)
Put the power-on BR80 close to the
main control of the helmet, and the
warning light flashes three times
per second, indicating that there is
a BR80 that needs to be connected
to the helmet.
Note:
A.
The left and right turn signal of the helmet can be controlled by the BR80's left (L) and right (R) buttons;
B.
The product works mainly by the left (L) and right (R) buttons of BR80 ,and the red confirmation button
in the middle of BR80.Other buttons are applicable for other models of LIVALL helmets.
Automatic Standby
After the helmet powers on and stays stationary for a while, it will automatically begin saving power by going into
sleep mode. When the tail light is off, without user interaction, the helmet is in sleep mode.
Automatic Wake Up
To wake up the helmet, shake it several times until the tail lights illuminate.
Note: If the helmet does not wake up, make sure the battery levels are adequate.
Press the power button of the
helmet within 10s to confirm the
connection of the BR80.
Then the tail light of the helmet will
continue to flash in the light mode
before connection.
connected successfully, the left
turn signal or right turn signal can
be controlled by the BR80.
After
4