Hama 00176606 Bedienungsanleitung Seite 4

• Before mounting, check that the wall you have
chosen is suitable for the weight to be mounted.
Also make sure that there are no electric, water,
gas or other lines running through the wall at the
mounting site.
• Electrical cables must never become trapped or
twisted between the product and the surface.
• If the product is attached to a metal surface,
it must be connected to an earth lead or the
installation's potential equalising cable.
• Only use the article under moderate climatic
conditions.
• Do not use the product in areas in which
electronic products are not permitted.
• Do not use the product in a damp environment
and avoid splashing water.
• Do not bend or crush the cable.
• Do not attempt to service or repair the product
yourself. Leave any and all service work to
qualified experts.
• Do not continue to operate the device if it is
visibly damaged
• No bare spots must be visible after connection
Warning
• Please note that lights (even LEDs) can gene-
rate heat and may become hot. Always let
the light cool down for a few minutes before
touching it.
• The device can only be operated on a 230
V 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certified in your country. The
applicable accident prevention regulations must
be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch off
the automatic circuit breaker). Failure to comply
with the installation instructions can cause fires
or other hazards.
Risk of electric shock
Do not open the product and do not operate it if
it is damaged, if smoke, a strange smell or loud
noises are coming from it. Immediately contact
your dealer or our service department (see item
"Service and Support").
Note
The light source of this light is not replaceable;
when the light source has
reached the end of its life,
you need to replace the
entire light.
Warning
Never look straight into the light source and do
not aim its beam of light straight into the eyes of
other people or animals. This could
damage your/their eyes.
Note
This light contains a light source of energy
efficiency class "F".
5. Product characteristics
• The SMART LED light can be connected to your
wireless home network via WiFi and serves as
illumination in indoor rooms or outdoor areas.
• It can be controlled via a mobile device (mobile
phone/tablet) as well as via the Amazon Alexa /
Echo and Google Home Voice services.
• A selection of voice commands is available,
such as:
Switch on / off
"Alexa / OK Google, switch the light on / off."
Dim to X %
"Alex / OK Google, reduce the light to X %".
Dim by X %
"Alexa / OK Google, increase the light X %."
Colour temperature selection
"Alex / OK Google, switch the light to warm
white." (white, daylight, etc.)
3