Hama 00176606 Bedienungsanleitung Seite 5

6. Installation
• Switch off the relevant fuse (fuse box) for the
room in which you wish to install the light.
• Check that the wires are de-energised using a
suitable measuring device (e.g. multimeter).
• Pull the housing upwards and off.
• Loosen the grub screws on the side using the
Allen key provided.
• Never look straight into the light source and do
not aim its beam of light straight into the eyes
of other people or animals. This could damage
your/their eyes.
• Please note that lights (even LEDs) can generate
heat and may become hot. Always let the light
cool down for a few minutes before touching it.
• Pull the wires through the hole (with rubber
insulation) on the mounting plate and attach
the insulation tubes. The tubes must cover the
connecting cable inside the light up to the
terminals. Shorten any connecting wires that
are too long.
• Insulate the cables as specified on the terminals
(10 mm).
• No earth wire can be connected to the lamp, nor
should it be.
• Attach the mounting plate to the wall using the
screws and dowels supplied.
• Connect the wires to the light terminals. Please
ensure that the seal is correctly inserted.
• Place the wall light on the mounting plate and
tighten the grub screws on the side.
• Now push the housing back onto the wall light.
7. Integrating devices into the Hama Smart
Solution app
• Switch the fuse back on.
• Connect the product to your wall switch.
• The product starts to flash quickly. If it does
not, switch it ON and OFF 3 times using the
light switch.
• Now open the Hama Smart Solution app and
sign in.
• Press the "+ in the top right-hand corner to add
a new device.
My Home
4