Levenhuk Ermenrich Reel GM60 Bedienungsanleitung Seite 5

Calculations with angle measuring (Pythagorean
theorem)
Single distance measurement
In Single distance measurement mode, aim the laser beam at the target and press (4). The value will be displayed on the screen. The angle
will be calculated and displayed on the screen at the same time.
Continuous measurement
In Single distance measurement mode, press (4) for 3 seconds. The device will keep taking measurements one after another. MAX, MIN,
and the last measured values (Fig. B) will be displayed on the screen. The angle will be calculated and displayed on the screen at the
same time.
Area measurement
Select the Area measurement mode. Aim the laser beam at the target and press (4) to measure 2 sides of the target. The area will be
calculated automatically (Fig. C).
Volume measurement
Select the Volume measurement mode. Aim the laser at the target and press (4) to measure the length, width, and height of the three-
dimensional target. The volume will be calculated automatically (Fig. D).
Calculations with 2 additional measurements (Pythagorean theorem)
Select the Calculations with 2 additional measurements (Pythagorean theorem) mode. Aim the laser at the target and press (4) to
measure the lines А and В (Fig. E). Line C will be calculated automatically.
Calculations with angle measuring (Pythagorean theorem)
Select the Calculations with angle measuring (Pythagorean theorem) mode. Aim the laser at the target and press (4) to measure the line
А (Fig. E). Lines B and C will be calculated automatically. The angle will be calculated and displayed on the screen at the same time.
Battery status
Figure B
Length
Width
Area
Figure C
Length
Width
Height
Volume
Figure D
5
MAX value
MIN value
Current value