Balluff BGL 50F-001-00,2-S4 Bedienungsanleitung Seite 3

Photoelectric Sensors
Stainless steel Slot Sensors BGL 50F-/80F- _ _ _-00,2-S4
Safety Notes
These photoelectric sensors may not be used in
applications where personal safety depends on
proper function of the devices (not safety
designed per EU machine guideline). Read
these operating instructions carefully before
putting the device into service.
Exempt Group according to IEC 62471:2008.
DO NOT STARE INTO THE EMITTER!
The sensor must be installed so that no direct
looking into the emitter is possible even during
operation.
The CE Marking confirms that our products
conform to the EC Directives 2004/108/EEC
(EMC) and the EMC Law.
In our EMC Laboratory, which is accredited by
the DATech for Testing of Electromagnetic
Compatibility, proof has been documented that
these Balluff products meet the EMC require-
ments of the harmonized standard EN 60947-5-2.
Wiring diagramm
1 BN 10...30 V
2 WH NC
3 BU GND
4 BK NO
Fig. 1: Connection diagram, pinouts
Display elements on the connector
LED green: Power on indicator
LED yellow: Output function indicator
3
Order code Slot sensor
BGL004L BGL 50F-001-00,2-S4
BGL004M BGL 50F-007-00,2-S4
BGL004N BGL 80F-001-00,2-S4
BGL004P BGL 80F-007-00,2-S4
Installation
Attention!
Do not stare into the light beam.
BGL 50F-...
BGL 80F-...
Fig. 2: Dimensions
Slot wide Light type
50 mm red light
50 mm IR
80 mm red light
80 mm IR