Designated Use; General Safety Instructions; Safety Instructions - Htronic TSM 1000 Anleitung

1. DESIGNATED USE

The device is designed to switch a connected device (230 V ~/50 Hz, Max.
5A, 1000VA) according to a preprogrammed temperature. The temperature
switching range is adjustable from –99°C to + 850°C in steps of 1°C. Any
other use is not permitted.

2. GENERAL SAFETY INSTRUCTIONS

– This device should not be handled or installed by persons with reduced
physical, sensory or mental capabilities or lack of experience (including
children) other than if supervised by a trained, responsible person.
– Children may not play with this device and should be supervised when
present.
– This device may only be connected to a properly installed power socket. The
voltage must match the specifications depicted on the nameplate of the unit
or mentioned in this instruction manual.
– Keep the mains power cord away from sharp edges, moisture, heat or oil.
– Do not connect the device if the power cord is damaged. In order to avoid
a hazard or electrocution, a damaged power cord must be replaced
immediately by our service centre or a similarly qualified person.
– If the power cord is damaged unplug the device immediately and replace the
power cord accordingly by our service centre or a similarly qualified person.
– Unplug the device if it is not used over a longer period of time.
– Keep the packing material and the plastic bags away from infants. There is
a danger of suffocation.
– When installing the device, install all cables so that they do not become a
tripping hazard or can accidentally be pulled out.
– When disconnecting the device from the mains, pull the plug out of the socket.
Do not pull at the power cord.

3. SAFETY INSTRUCTIONS

When handling electrical devices, the VDE regulations have to be applied.
Especially VDE 0100, VDE 0550/0551, VDE 0700, VDE 0711 and VDE 860.
– This device may not be modified in any way. The CE conformity has been
declared and proven and the corresponding document is deposited with the
manufacturer.
18 | Designated use
– Before opening the device, please disconnect it from the mains and/or make
sure that it is not connected to an electrical current.
– Tools may only be used if the device is disconnected from the mains.
– All connecting cables should regularly be inspected for any damages on the
insulation.
– Should any damages be found, disconnect the device immediately from the
mains and repair or exchange it.
Should there be any open questions on the installation, the devices connected,
the functions, the maintenance, the safety or any other point concerning this
device, please contact a specialist or a qualified person.
Before installing and using this device, please make sure that it and the attached
devices are suitable and compatible. In no event will liabilities be taken for
consequential or incidental direct or indirect damages resulting from improper
use or incorrect installation of the device.
This item was tested and manufactured according to EU regulations 2014/35/
EU und 2004/108/EG and holds the corresponding CE approval. Any
change of the circuitry or exchange of components other than specified will
invalidate this approval.
MALFUNCTION
Only use the device if it is functioning without disturbance. If there is any
malfunction, switch off the device immediately and consult a specialist. The
device may only be reinstalled after it has been checked thoroughly. Signs of
malfunction are if:
– The device is visibly damaged.
– The device is malfunctioning.
– Attached cables or the housing has become loose.
Repairs may only be done by a qualified person or a specialist using original
components and parts. There is the danger of electrocution.
Temperature Switch TS 1000 | 19