Waring commercial BOLT WSB38XE Bedienungsanleitung Seite 7

BEFORE YOU BEGIN
After unpacking your new immersion blender, wipe the exterior of the
motor housing and battery pack with a clean, damp cloth to remove
any dirt or dust that may have accumulated during shipping. While
the stainless steel shaft is detached, rinse under running water, being
sure to rinse the metal blade. Dry thoroughly with a soft, absorbent
cloth. CAUTION: Blade is sharp.
CHARGING INSTRUCTIONS
CAUTION: Charge and store the battery pack at room temperature
only. Avoid exposure to high temperatures to prevent damage.
Before first use, place the battery pack into the battery quick-charge
station and charge for 1.5 to 2 hours. Charge indicator light will
illuminate when properly placed. Blinking green light indicates
battery is charging, and solid green light indicates that it is
fully charged.
To remove the battery from the motor housing or the quick-charging
station, press the blue clips inward and lift the battery up.
When the unit is assembled, you can check the level of charge by
holding down on the safety button for around 6 seconds. The speed
indicators will illuminate in red; if all the lights are lit, battery is fully
charged. If only one light is lit, the battery charge is low.
USING YOUR WARING
ASSEMBLY
1. Attach the stainless steel shaft to the motor housing by aligning
the metal coupling on the housing with the coupling on the
shaft. Turn clockwise to secure.
2. Insert the battery pack onto the top of the motor housing.
Battery pack will click into place.
OPERATION
1. Plunge the immersion blender into the pot/mixing vessel. DO
NOT SUBMERGE MORE THAN ¾ OF THE SHAFT.
2. The immersion blender has two buttons: safety (back) and
power (front). To start unit, press the safety and power buttons
simultaneously. Release the safety button, but keep pressing
the power button for as long as you wish to blend.
IMMERSION BLENDER
®
7