Before You Start; Wire Antenna; Connecting The Power Adapter; Getting Started - Silvercrest SURQ 4 A1 Bedienungsanleitung Und Sicherheitshiweise

SilverCrest SURQ 4 A1

9. Before you start

Position the device on a stable, flat surface and do not place any heavy objects on it.

9.1 Wire antenna

A wire antenna (17) can be found on the rear of the device. It is wound up on delivery. Unwind it
completely to improve the reception on the radio.

9.2 Connecting the power adapter

Connect the connector of the power adapter (B) supplied into the power adapter connection (20)
on the back of the radio. Plug the power adapter (B) into an easily accessible mains socket. "SYNC"
appears at the bottom of the display (1). When it is first started up and after a reset, the device
automatically displays the correct time, then scans for all available stations in the DAB and FM
frequency bands and saves them. This process may take a few minutes.
Note: To start this process after resetting the device, unplug the power plug and then plug it in again
after the display has turned off completely.
If there RF interference or the reception conditions are not favourable, e.g. in buildings
with thick walls, the reception of the time signal via DAB+ or RDS can be impaired or even
impossible. In this case, you can set the time manually as described in the chapter "Manual
time setting".
The default settings and saved radio stations are stored permanently and automatically
restored after a power cut.
The time is updated via DAB+ or RDS after a power cut.

10. Getting started

10.1 Display lighting

You can adjust the display brightness to your needs in 3 steps. To do this, press the [SNOOZE] button
(10) multiple times until the display is the brightness you want.
Press and hold the [SNOOZE] button (10) for approx. 2 seconds to switch the display (1) off. The
display (1) switches to the lowest brightness level for about 10 seconds as soon as a button is
pressed. Press the [SNOOZE] button (10) briefly to switch the display (1) back on permanently.

10.2 Switching the device on/off

Press the [ ] button (7) briefly to switch the radio on. Press the [ ] (7) button briefly to switch the
device into standby mode.
16 - English