Cleaning And Care - EASYmaxx XPB30-8 Bedienungsanleitung

EN
When the washing time is up, the
device switches off automatically.
11. Drain the water via the discharge hose
into a sink or similar outlet (Picture E).
Rinsing
12. Fill the washing drum again with clear
water that is cold or lukewarm, but do
not add any detergent to it.
13. Set the dial to Waschen (wash) and
the dial Timer to the time you want
(max. 15 minutes).
The device will start the rinse cycle.
When the rinsing time is up, the de-
vice switches off automatically.
14. Drain the water via the discharge hose
into a sink or similar outlet.
Spinning
15. Open the lid and take the wet laundry
out of the washing drum.
16. Divide up the wet laundry if necessary
and place max. 1.5 kg in the spinning
drum (8) (Picture F).
17. Place the cover on the spinning drum.
18. Place the spinning drum inside the
washing drum. Make sure when you
do this that it fi ts correctly on the hub
(7).
PLEASE NOTE: To ensure that the
spinning drum does not jump off the
hub while it is spinning, the recesses
in the bottom of the spinning drum
must fi t correctly on the mating parts
on the hub.
19. Close the lid.
20. Make sure that the discharge
hose leads into a sink or similar outlet
so that the water can drain away
during spinning.
21. Set the dial to Schleudern (spin) and
the dial Timer to the time you want
(max. 15 minutes).
The device will start the spin cycle.
When the spinning time is up, the
device switches off automatically.
22. Open the lid.
14
07475_DE-EN-FR-NL_A5_V3.indb 14 07475_DE-EN-FR-NL_A5_V3.indb 14
23. Once the spinning drum has come to
a complete stop, remove it from the
washing drum.
24. Remove the laundry from the spinning
drum and hang it up in the usual way.
If the laundry is still too wet, repeat
the spin cycle.
25. Turn the dial to Aus (off) and pull the
mains plug out of the plug socket.

CLEANING AND CARE

Please Note!
■
Do not use any caustic or abrasive
cleaning agents or cleaning pads to
clean the device. These may damage
the surfaces.
• Wipe down the device with a damp
cloth if necessary.
• Clean the washing drum (4) with a
clean, damp and soft cloth and a little
detergent. Then allow a rinse cycle to
run through with clear water (see the
"Use" chapter – "Rinsing").
• Allow the device and all accessories
to dry completely.
• Remove limescale deposits regularly
(6 – 8 weeks) with a standard descal-
ing agent to constantly maintain the
quality of the water and the effi ciency
of the device.
• Keep the device ready to operate and
check it regularly for any damage.
• Store the device in a dry, clean, frost-
free place that is protected from di-
rect sunlight and cannot be accessed
by children or animals.
01.07.2021 16:08:12 01.07.2021 16:08:12