EASYmaxx XPB30-8 Bedienungsanleitung Seite 13

USE
Please Note!
■
Make sure that the connecting cable
and the discharge and feed hoses are
not crushed, bent or laid over sharp
edges and do not come into contact
with hot surfaces.
■
Water that is hotter than 60°C must
not be used as otherwise the plastic
trough could be deformed.
■
Remove all objects such as keys, small
change, etc. from pockets or other
places to prevent any damage to the
textiles and the device.
■
Make sure that during the wash cycle
the discharge hose is always secured
vertically on the suspension device.
■
Do not open the lid while the device
is operating.
 
Before the fi rst wash cycle with
laundry, the device should be
cleaned as it may have possible
production residues on it. To
do this, run a wash cycle WITH-
OUT any laundry for approx. 15
minutes.
Setting Up
1. Place the device on a dry, level, solid
and water-resistant surface. Ensure
there is suffi cient clear space on all
sides (at least 20 cm to the sides and
50 cm above).
2. Attach the discharge hose (3) using
the hook to the suspension device (2).
Filling
 
Always read the washing labels
on the textiles!
Wash fi ne textiles such as wool or
silk in a wash bag or something
similar in order to preserve the
fabrics.
07475_DE-EN-FR-NL_A5_V3.indb 13 07475_DE-EN-FR-NL_A5_V3.indb 13
Always close zips!
Brush off coarse dirt such as sand,
glue, etc. beforehand so that the
discharge fl ow does not become
clogged up.
3. Open the lid (1) and fi ll the washing
drum (4) with no more than 3 kg of
laundry (Picture C).
4. Connect the feed hose to the sock-
et (9) on the device.
5. Plug the tap adapter onto the feed
hose and then connect it to a tap.
Tighten the clip.
 
If the adapter does not fi t on the
tap, simply hold the feed hose
under the tap (Picture D).
6. Allow clear, warm water (max. 60°C)
to run into the washing drum up to
the MAX marking.
 
If there is no hot water available
nearby, the washing drum can
also be fi lled using a bucket.
7. Pour detergent that is suitable for the
textiles into the washing drum. Note
that less detergent is required than in
a conventional washing machine.
8. Close the lid.
Connecting
9. Connect to a plug socket that is
properly installed. The mains voltage
must match the technical data of the
device.
The plug socket must be readily ac-
cessible so that the connection to the
mains can quickly be isolated.
Washing
10. Set the dial (10) to Waschen (wash)
and the dial Timer (11) to the time
you want (max. 15 minutes).
The device will start the wash cycle.
EN
13
01.07.2021 16:08:12 01.07.2021 16:08:12